training:apnic-ipv6-nc:0-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
training:apnic-ipv6-nc:0-setup [2018/03/19 18:29] – [Explanations for some of the commands used] philip | training:apnic-ipv6-nc:0-setup [2018/04/07 17:40] (current) – [Introducing the lab] philip | ||
---|---|---|---|
Line 4: | Line 4: | ||
===== Objective ===== | ===== Objective ===== | ||
+ | This lab sets up the dual stack infrastructure which will be used for the rest of the topics explored in this workshop. | ||
- | |||
- | Using a dual stack topology, this lab investigates securing the router and the routing infrastructure for the network. | ||
===== Lab Topology ===== | ===== Lab Topology ===== | ||
Line 22: | Line 21: | ||
==== Introducing the lab ==== | ==== Introducing the lab ==== | ||
- | This workshop uses Cisco IOS routers running IOS, but on the Dynamips | + | This workshop uses Cisco routers running IOS, but on the Dynamips |
The lab will have been preconfigured by the instructors, | The lab will have been preconfigured by the instructors, | ||
Line 145: | Line 144: | ||
==== Loopback ==== | ==== Loopback ==== | ||
- | First we will configure | + | First we will create |
**On CX:** | **On CX:** | ||
Line 155: | Line 154: | ||
- | You will need a similar configuration | + | You will need a similar configuration |
==== Links to other Routers ==== | ==== Links to other Routers ==== | ||
Line 227: | Line 227: | ||
This prevents the router from sending any prefixes as part of router advertisements, | This prevents the router from sending any prefixes as part of router advertisements, | ||
- | |||
- | ==== Loopback interface ==== | ||
- | |||
- | Also create the Loopback interface and apply the IPv4 and IPv6 addresses to it - consult the address plan for the addresses used. Here is an example for the Core router in the autonomous system. Remember that the IPv4 address on the Loopback is a /32 and the IPv6 address on the Loopback is /128. | ||
- | |||
- | interface Loopback0 | ||
- | | ||
- | ip address 100.68.X.2 255.255.255.255 | ||
- | ipv6 address 2001: | ||
- | ! | ||
- | |||
training/apnic-ipv6-nc/0-setup.1521444557.txt.gz · Last modified: 2018/03/19 18:29 by philip