Differences

This shows you the differences between two versions of the page.

--- training:itu-ipv6-2018:0-setup [2018/04/08 16:24] – [Configure Authentication] philip
+++ training:itu-ipv6-2018:0-setup [2018/05/15 15:07] (current) – [Summary of the commands entered] philip
@@ Line 6: / Line 6: @@
-This lab sets up the dual stack infrastructure which will be used for the rest of the topics explored in this workshop.
+Using a dual stack topology, this lab investigates securing the router and the routing infrastructure for the network.
 ===== Lab Topology =====
@@ Line 22: / Line 23: @@
 ==== Introducing the lab ====
-This workshop uses Cisco routers running IOS, but on the Dynamips system – Dynamips translates the Cisco 7200 router processor instructions in IOS to those of the Intel based host system, allowing Cisco IOS images, and therefore network configurations, to be run on a host PC system (usual Linux or MacOS based).
+This workshop uses Cisco routers running IOS, but on the Dynamips system – Dynamips translates the Cisco 7200 router processor instructions in IOS to those of the Intel based host system, allowing Cisco IOS images, and therefore network configurations, to be run on a host PC system (usual Linux or macOS based).
 The lab will have been preconfigured by the instructors, allowing participants to enter the following exercises directly. Please read the following steps carefully.
@@ Line 127: / Line 128: @@
 === Usernames and Passwords ===
-All router usernames should be **v6lab** and password should be **lab-PW**. Configuration mode password should be **lab-EN**.
+All router usernames should be **seclab** and password should be **lab-PW**. Configuration mode password should be **lab-EN**.
 === service password-encryption ===