training:sanog32:0-setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
training:sanog32:0-setup [2018/07/23 16:03] – [Links to other Routers] philip | training:sanog32:0-setup [2018/07/24 11:04] – [Loopback] philip | ||
---|---|---|---|
Line 17: | Line 17: | ||
The lab will start simply by configuring each autonomous system, and making sure that transit works via their transit provider. The address plan for the entire network is described in the [Address Plan](address-plan) document. The initial set up is shown below. | The lab will start simply by configuring each autonomous system, and making sure that transit works via their transit provider. The address plan for the entire network is described in the [Address Plan](address-plan) document. The initial set up is shown below. | ||
- | {{: | + | {{: |
===== Preliminary ===== | ===== Preliminary ===== | ||
Line 40: | Line 40: | ||
- | The following configuration examples show the suggested/ | + | The following configuration examples show the suggested/ |
==== Name the router ==== | ==== Name the router ==== | ||
Line 154: | Line 154: | ||
- | You will need a similar configuration to create the Loopbacks on the Peering, Access and Border router as well. The Customer router does not have a Loopback. | + | You will need a similar configuration to create the Loopbacks on the Peering, Access and Border router as well. |
training/sanog32/0-setup.txt · Last modified: 2018/07/24 11:04 by philip