Philip Smith's Internet Development Site

User Tools

Site Tools

Trace:
training:sanog32:d-dhcpv6pd

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Last revisionBoth sides next revision
training:sanog32:d-dhcpv6pd [2018/08/05 20:51] – [Setting up the Customer Router] philiptraining:sanog32:d-dhcpv6pd [2018/08/05 20:53] – [Setting up the Customer Router] philip
Line 105: Line 105:
 With the Access Router configuration now completed, we can turn our attention to the Customer router configuration. With the Access Router configuration now completed, we can turn our attention to the Customer router configuration.
  
-We need to configure the point-to-point link to the Access Router to request an IPv6 address block by DHCPv6-PD. We will use a feature in Cisco IOS called “general-prefix”. This allows us to refer to learned addresses (by 6rd, DHCPv6PD etc) without configuring specific addresses on each prefix.+We need to configure the point-to-point link to the Access Router to request an IPv6 address block by DHCPv6-PD. We will use a feature in Cisco IOS called `general-prefix`. This allows us to refer to learned addresses (by 6rd, DHCPv6PD etc) without configuring specific addresses on each prefix.
  
 This following configuration example will do the needful: This following configuration example will do the needful:
training/sanog32/d-dhcpv6pd.txt · Last modified: 2018/08/17 18:00 by philip