Lab Access Instructions
This lab runs on a virtualised environment for Cisco IOS called “Dynamips”.
To join the network which the lab environment is on, associate your laptop with the wireless network called NSRC-PFS. The password for this network is 888888888 - this is ten times the number 8.
The method of access to each virtual router is via Telnet to a specific port on the IP of the machine that runs the virtualization platform.
$ telnet 10.10.0.241 2012
Dynamips Port to Router Console Map
After executing the telnet command, you will see something like the following:
Trying 10.10.0.241... Connected to 10.10.0.241. Escape character is '^]'. Connected to Dynamips VM "R32" (ID 8, type c7200) - Console port
Hit ENTER at this point. Then, if you see this question:
Would you like to enter the initial configuration dialog? [yes/no]:
The router will show some initialization routines, and finally, you will see the default prompt:
You can then go into privileged mode:
Router> enable Router#
And then enter configuration mode:
Router# configure terminal Router(config)#
And you are ready to start entering configuration statements. When you are done, exit configuration mode by typing *end* or pressing *ctrl-Z* and save your changes:
Router(config)# end Router# write memory